Configuration MP.11-R Installation and Management
VLAN Parameters
117
BSU VLAN Configuration
The HTTP Interface to configure BSU VLAN parameters is shown in the following figure.
Configure the following parameters:
• BSU VLAN Mode: The BSU VLAN mode can be either Transparent, Trunk, or Mixed. By default, the BSU is in
Transparent mode.
• Management VLAN ID: The Management VLAN ID is configurable in any mode. The management VLAN ID has a
default value of untagged and may be configured with a value in the range of 1 to 4094.
• Management VLAN Priority: The Management VLAN priority values range from 0 to 7 and the default priority is 0
(zero).
• Relaying Flag: When this flag is enabled, the BSU relays frames between SUs on the same BSU.
NOTE: This feature is applicable for Trunk and Mixed mode only.
• BSU VLAN Table: The BSU VLAN Table is configurable in both Transparent and Trunk mode, but applies only when
the BSU is in Trunk mode or Mixed mode. The VLAN ID values for the BSU VLAN Table range from 1 to 4094. The
maximum number of VLAN IDs that can be configured in the BSU VLAN Table is 256. An SU in Trunk mode is
assigned VLAN IDs from this table.
Add BSU VLAN Table Entries
To add entries to the BSU VLAN table, click Add Table Entries. Enter a VLAN ID and select a Status, then click Add to
add your entry to the table.
To Next Page
Loading...
Need help?
General
