Configuration MP.11-R Installation and Management
Security Parameters
97
Security Parameters
MAC Authentication (BSU Only)
Click Configure > Security > MAC Auth to build a list of authorized wireless stations that can register at the unit and
access the network. MAC Authentication is supported on the wireless interface and only wireless MAC addresses should
be entered in the list. For example, you might build a list of wireless MAC addresses of SUs authorized on the BSU
NOTE: MAC authentication is available only for BSUs.
Add Entries to MAC Access Control Table
1. To add table entries, click Add Table Entries; a window such as the following is displayed:
2. Enter the MAC address and any comment, then click Add. The maximum number of MAC addresses that can be
entered is 250.
Edit/Delete Entries in MAC Access Control Table
1. To edit or delete table entries, click Edit/Delete Table Entries.
2. Make your corrections in the window displayed and click OK.
To Next Page
Loading...