Procedures MP.11-R Installation and Management
Configuration Backup
172
Configuration Backup
You can back up the unit’s configuration by uploading the configuration file. You can use this file to restore the
configuration or to configure another unit (see Configuration Restore).
To upload a configuration file through the Web Interface:
1. Set up the TFTP server as described in TFTP Server Setup.
2. Access the unit as described in Logging in to the Web Interface.
3. Click Commands > Upload.
4. Fill in the following details:
• Server IP Address: <IP address TFTP server>
• File Name: <configuration file name>
• File Type: Config
• File Operation: Upload
5. Click OK to start the file transfer.
The unit uploads the configuration file. The TFTP server program should show upload activity after a few seconds. When
the upload is complete, the configuration is backed up.
To Next Page
Loading...