MP.11-R Installation and Management
47
4
Basic Management
This chapter describes basic features and functionality of the unit. In most cases, configuring these basic features is
sufficient. The “Glossary” in the Tsunami MP.11/QB.11 Reference Manual provides a brief explanation of the terms used.
For CLI commands you can use for basic management, see “Command Line Interface” in the Tsunami MP.11/QB.11
Reference Manual.
The following topics are discussed in this chapter:
• Navigation
• Rebooting and Resetting
• General Configuration Settings
• Monitoring Settings
• Security Settings
• Default Settings
• Upgrading the Unit
Navigation
To use the Web Interface for configuration and management, you must access the unit. With ScanTool you can
determine the unit’s current IP address. Then enter http://<ip address> in your Web browser (for example http://
10.0.0.1). See Setting the IP Address with ScanTool for details.
NOTE: If you have your Security Internet Options set to High, you may not be able to access the Web interface
successfully; a high security setting disables JavaScript, which is required for running Proxim’s Web browser
interface. Adding the radio’s IP address as a Trusted site should fix this problem.
The Web Interface consists of Web page buttons and tabs. A tab can also contain sub-tabs. The following figure shows
the convention used to guide you to the correct tab or sub-tab.
The Web Interface also provides online help, which is stored on your computer (see Step 11: Install Documentation and
Software for details).
Click Configure > Interfaces > Wireless:
1
2
3
To Next Page
Loading...
Need help?
General
