Proxim Tsunami MP.11-R - Page 135

Configuration MP.11-R Installation and Management
QoS (Quality of Service) Parameters (BSU Only)
135
• IP Address or MAC Address: IP address or MAC Address of management station
• IP Mask or MAC Mask: 255.255.255.255 (for IP Mask) or FF:FF:FF:FF:FF:FF (for MAC mask)
17. Click Add.
Step 2: Add Service Flow Classes
To handle management traffic, the system needs two Service Flow Classes: one for uplink traffic, and one for downlink
traffic.
A. Configure the Downlink Service Flow
1. Click Configure > QoS > QoS SF Class.
2. Click Add Table Entries.
3. Enter the following parameters:
• SF Name: DL-Management
• SF Schd Type: RtPS
• SF Direction: Downlink
• MIR: 1000
• CIR: 1000
• Latency: 20
• Jitter: 10
• Priority: 7
• Number of Frames Per Burst: 4
• SF Entry State: Enable
4. Click Add. The DL-Management SF will be added to the QoS Service Flow Table.
B. Configure the Uplink Service Flow
1. Remaining on the Service Flow Entry Add page, enter the following parameters:
• SF Name: UL-Management
• SF Schd Type: RtPS
• SF Direction: Uplink
• MIR: 1000
• CIR: 1000
• Latency: 20
• Jitter: 10
• Priority: 7
• Number of Frames Per Burst: 4
• SF Entry State: Enable
2. Click Add. The UL-Management SF will be added to the QoS Service Flow Table.
NOTE:
The input and output bandwidth limits set on the BSU or on the SU are used for limiting aggregate bandwidth
used by singe SU. These limits override any limit imposed by MIR in the SFC; thus, these limits should be set to
at least 1000 kbps (MIR values in UL-Management and DL-Management SFCs).