Configuration MP.11-R Installation and Management
Network Parameters
70
Add Entries to the DHCP Server IP Pool Table
You can add up to 20 entries in the IP Pool Table. An IP address can be added if the entry’s network ID is the same as the
network ID of the device.
NOTE: After adding entries, you must reboot the unit before the values take effect.
1. To add an entry click Add Table Entries.
2. Enter the following parameters and click Add:
• Start IP Address: Indicates the starting IP address that is used for assigning address to hosts on the Ethernet
side in the configured subnet.
• End IP Address: Indicates the ending IP address that is used for assigning address to hosts on the Ethernet side
in the configured subnet.
• Default Lease Time: Specifies the default lease time for IP addresses in the address pool. The value is 3600-
86400 seconds.
• Max Lease Time: The maximum lease time for IP addresses in the address pool. The value is 3600-86400
seconds.
• Comment: The comment field is a descriptive field of up to 255 characters.
Edit/Delete Entries in the DHCP Server IP Pool Table Entries
1. Click Edit/Delete Table Entries to make changes
2. Enter your changes and click OK.
To Next Page
Loading...
Need help?
General
