Configuration MP.11-R Installation and Management
Interface Parameters
86
Satellite Mode
The mandatory parameters to configure for registration of the SU on a Base Station are:
• Network Name
• Base Station System Name (when used)
• Channel Frequency
• Encryption (when used)
•Network Secret
These and other parameters found on the SU’s Interfaces > Wireless page are described below.
• Interface Type: In Satellite mode, the interface type is WORP Satellite.
• MAC Address: The factory-assigned MAC address of the unit. This is a read-only field.
• Base Station System Name: The name found on the system page of the BSU to which this SU is connecting. This
parameter can be used as an added security measure, and when there are multiple BSUs in the network and you
want an SU to register with only one when it may actually have adequate signal strength for either. The System Name
field is limited to a length of 32 bytes.
If the Base Station System Name is left blank on the SU, it can register with any BSU with a matching Network Name
and Network Secret.
• Operational Mode: This field indicates the operational mode of the unit, depending upon the specific Tsunami MP.11.
This operational mode cannot be changed as it is based upon a license file.
To Next Page
Loading...
Need help?
General
