Page 14 of 110 150821/A4
Condensed Operating Instructions (Continued)
There are three main menus within the 1730T LCR Meter instrument software. Familiarize
yourself with these menus prior to programming a test. Figure COI-1 illustrates the MEAS
DISPLAY screen and lists the functions that can be accessed by pressing the [MAIN INDEX]
and [SYSTEM SETUP] keys.
MEAS DISPLAY
Function of F1 - F4 Keys
FREQ.: 100kHz
LEVEL: 1.00V
NEXT PAGE 1/4
PARA.: Cs - D
BIAS
LOCK
Cs : 1.2345 pF
D : 1.2345
MEAS
DISPLAY
SYSTEM
SETUP
MAIN
INDEX
SPEED
RANGE
BINNING
RECALL
BIN COUNT
BIN SET
STORE
CORRECTION
COMPARE
GPIB EOS Code
AVERAGE Time
LINK 1320
SETTING
STORE
COUNT
RECALL
GPIB ADDRESS Code
TRIGGER Edge
TRIGGER Delay
CONST Source
VM / IM Display
CABLE Length
BIAS Voltage
TRIGger
BEEPER
KEY LOCK
NEXT PAGE 2/4
BINNING
NEXT PAGE 1/4
FREQ.
LEVEL
PARAmeter
< MEAS DISPLAY >
SHORT
OPEN
INTEGER Cycle
HANDLER Mode
ALARM Mode
SOUND Mode
CONTRAST
F1
F3
F2
MEAS
DISPLAY
F4
TRI GGER
MAI N
INDEX
SYSTEM
SETUP
SYSTEM CONFIG
Vm:
Im:
1000.00mV
0.00mA
COMPARE
NEXT PAGE 3/4
BIAS Current
NEXT PAGE 4/4
Figure COI-1: 1730T Instrument Menus
NOTE:
The function keys [F1 – F4] are used to select the parameter to change and in some menus to
change the value of that selected parameter.
The function of UP/DOWN depends on the menu. In some menus, the LEFT/RIGHT keys are
used to select a digit by moving the underscored cursor left or right.
NOTE:
To exit REMOTE mode press [F1] [F4] [SYSTEM SETUP].
To Next Page
Loading...
Need help?
General