Interface 150821/A4 Page 81 of 110
3.1.5.4 CALCulate{1⏐2}:LIMit:BEEPer:CONDition
Instruction: CALCulate{1⏐2}:LIMit:BEEPer:CONDition
Parameter: {FAIL⏐PASS}
Return Value: None
Function: Set condition upon which Beeper sounds.
Description: FAIL Beeper sounds when comparison result is a FAIL
PASS Beeper sounds when comparison result is a PASS
3.1.5.5 CALCulate{1⏐2}:LIMit:BEEPer:STATe
Instruction: CALCulate{1⏐2}:LIMit:BEEPer:STATe
Parameter: {ON (1)⏐OFF (0)}
Return Value: {1⏐0}
Function: Set or query status of beeper.
Description: (1) Turn on Beeper
(0) Turn off Beeper
3.1.5.6 CALCulate{1⏐2}:LIMit:BEEPer
Instruction: CALCulate{1⏐2}:LIMit:BEEPer
Parameter: {OFF (0)⏐LOW (1)⏐HIGH (2)}
Return Value: {0⏐1⏐2}
Function: Set or query if beeper is ON or OFF.
Description: (0) Turn off Beeper
(1) Turn on Beeper (LOW)
(2) Turn on Beeper (HIGH)
3.1.5.7 CALCulate{1⏐2}:LIMit:LOWer[:DATA]
Instruction: CALCulate{1⏐2}:LIMit:LOWer[:DATA]
Parameter: {The lower limit value⏐MAXimum⏐MINimum}
Return Value: The lower limit value, the format is <NR3> (Floating point)
Function: Set or query the lower limit value.
Description: MINimum -9.999E14
MAXimum 9.999E14
3.1.5.8 CALCulate{1⏐2}:LIMit:STATe
Instruction: CALCulate{1⏐2}:LIMit:STATe
Parameter: {ON (1)⏐OFF (0)}
Return Value: {1⏐0}
Function: Set or query if the Compare function is ON or OFF.
Description: ON (1) Turn on Compare function
OFF (0) Turn off Compare function
To Next Page
Loading...