Page 84 of 110 150821/A4 Interface
3.1.5.19 DISPlay[:WINDow] :TEXT1:PAGE
Instruction: DISPlay[:WINDow]:TEXT1:PAGE
Parameter: {1⏐2}
Return Value: {1⏐2}
Function: Set or query which screen is shown.
Description: 1 Measuring screen
2 Comparison screen
3.1.5.20 DISPlay[:WINDow]:TEXT2:PAGE
Instruction: DISPlay[:WINDow]:TEXT2:PAGE
Parameter: {1⏐2⏐3⏐4}
Return Value: {1⏐2⏐3⏐4}
Function: Set or query which page of MEAS DISPLAY is shown.
Description: 1 Page 1 of MEAS DISPLAY (Freq, Level, Parameter)
2 Page 2 of MEAS DISPLAY (Range, Speed, Trigger)
3 Page 3 of MEAS DISPLAY (Bias, Binning, Compare)
4 Page 4 of MEAS DISPLAY (Bias I, Bias I)
3.1.5.21 FETCh?
Instruction: FETCh?
Parameter: None
Return Value: <STATE>, <DAT1>, <DAT2>, <CMP1>, <CMP2>
Function: Get the result from the INITiate function.
Description: <STATE> Measuring status
1 Normal
2 Overload
3 DUT disconnected
<DAT1> test value of primary parameter
<DAT2> test value of secondary parameter
When the Compare function is enabled, results are:
<CMP1> comparison value of primary parameter
<CMP2> comparison value of secondary parameter
0 No secondary parameter
1 Test value in range
2 Test value too high
4 Test value too low
8 DUT disconnected
NOTE: Use the *TRG command to initiate a measurement and get the data back in a single command.
To Next Page
Loading...