Q24/Q48 Tape Library Installation and Operations Manual
o Gateway address - Used to set the Gateway Address; contact your Network administrator to
receive this address if required (used when an IP address does not match any other routes in
the routing table)
o IPv4 DNS Server 1 - This is the IP address of your name server (DNS server). A DNS server
allows the library to communicate with other network clients via their host name. If you have
a DNS Server on your network, enter the IP address in this field.
o IPv4 DNS Server 2 - This is the alternate IP address of your name server (DNS server). A DNS
server allows the library to communicate with other network clients via their host name. If
you have a DNS server on your network, enter the alternate IP address in this field.
• IPv6
o IPv6 DNS Server 1 - This is the IP address of your name server (DNS server). A DNS server
allows the library to communicate with other network clients via their host name. If you have
a DNS Server on your network, enter the IP address in this field.
o IPv6 DNS Server - This is the alternate IP address of your name server (DNS server). A DNS
server allows the library to communicate with other network clients via their host name. If
you have a DNS server on your network, enter the alternate IP address in this field.
o Stateless Auto Configuration
o DHCPv6 Addressing - Used to enable DHCP addressing assignment from the network name
server
o Static Addressing - Used to enable a static IP address for the RMU access
o Static Address - Setting of the static IP address for the RMU
• Enable SSL for Web
3.2.7.6 Changing the SNMP settings
If a host and domain name is entered instead of an address, the IPv4 or IPv6 address will be resolved
from the DNS using that name. The IP address will be stored in the library rather than the name.
Therefore, if the address changes then the name or a new address will have to be entered.
© Copyright QUALSTAR 2015 49
To Next Page
Loading...
