EasyManuals Logo
Home>Quantum>Storage>DXi V-Series

Quantum DXi V-Series User Manual

Quantum DXi V-Series
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Network CLI Commands 107
--domain: Sets the system's domain name.
--dns: Sets the DNS search path. Can specify up to 3 IP addresses. DNS will
search each path in the order of the specified IP addresses.
--defaultgateway: Sets the system's default gateway.
--sure: If specified, the command will execute without asking for
confirmation.
Editing the Network
Configuration
syscli --edit netcfg --devname <DEVNAME> [--mtu <1500|9000>] [--mode
RR|AB|LACP] [--slaves <DEV1>,<DEV2>,<...>] [--nat <NAT_IPADDR>] [--
extHostIp YES|NO] [--sure]
This CLI allows the admin user to update the MTU, bonding mode or slaves for
an existing L2 network device.
Note: The system does not automatically reboot; therefore, after making any
modification to your network configuration, you must manually reboot
the system. You can reboot the system using the sysclil --nodemanage
--reboot command.
CLI command options:
--edit: Updates the MTU, bond mode or slaves for an existing L2 network
device.
--devname: Device name. The general format is <label><devno> where
label: Device label, which is an alphabetic string (e.g. bond, eth, ...)
devno: Device number, which can range from 0 to possibly 99,
depending on actual systems.
--mtu: Enter 1500 to set MTU size to the standard (STD) frame size of 1500
bytes. Enter 9000 to set MTU size to allow up to the max JUMBO frame size
of 9000 bytes. If this line is not entered, 1500 (the STD frame size) will be
used.
--mode: Mode must be specified when creating a bond. Currently Round
Robin (mode 0), Active Backup (mode 1) and LACP (mode 4) are supported.
--slaves: If --slaves is specified, specify two or more slave device names
separated by commas.
--nat: Specified on the target if the source needs to use this NAT IP address
for replication.
--extHostIp: Mode must be specified when creating a netcfg.
--sure: If specified, the command will execute without asking for
confirmation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum DXi V-Series and is the answer not in the manual?

Quantum DXi V-Series Specifications

General IconGeneral
BrandQuantum
ModelDXi V-Series
CategoryStorage
LanguageEnglish

Related product manuals