Quantum DXi V-Series - Adding a Source on a Target; Deleting a Source on a Target; Listing the Replication Targets for the Source

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
42 Replication CLI Commands
Adding a Source on a
Tar g e t
syscli --add sourcerep --hostid <host_id>
This CLI command allows the admin user to add or specify the replication source
IP or hostname of a source DXi system for this system as a target.
Deleting a Source on a
Tar g e t
syscli --del sourcerep --hostid <host_id>
This CLI command allows the admin user to delete the given source IP or
hostname as a replication source on this target system.
Listing the Replication
Targets for the Source
syscli --list targetrep
This CLI command lists all allowed replication target IP addresses or hostnames
for this system as a source. If a replication target host has been configured, the
CLI displays any available replication statistics, as well as pause/resume status.
Output data:
ListofallallowedreplicationtargetIPforthissystemasa
source:
Totalcount=2
[targetrep=1]
TargetHost=10.40.162.229
SourceIP=0.0.0.0
Encryption=Enabled
EncryptionType=256‐BIT
ProgramRepPaused= no
UserRepPaused=no
NASRepSupported=yes
VTL
RepSupported=yes
RepRevision=6
[targetrep=2]
TargetHost=10.40.164.14
SourceIP=0.0.0.0
Encryption=Enabled
EncryptionType=256‐BIT
ProgramRepPaused= yes
UserRepPaused=no
NASRepSupported=yes
VTLRepSupported=yes
RepRevision=0