Quantum DXi V-Series User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
VTL Configuration CLI Commands 17
for each host. If the host alias was not added initially, the output will indicate
that no alias was given.
An example output of a host with no alias given is shown below.
Listofavailablehosts:
Totalcount=1
[host=1]
wwpn=220100e08ba8338d
alias=null
connectionstatus=active
Adding a Host syscli --add host -wwpn <host_world_wide_port_name> --alias
<host_alias>
This CLI command allows the CLI admin to add a host to the available host list.
The required parameters are the host's world wide port name (WWPN) and alias.
If the host already exists from the list of available hosts, adding the same host
will return an error.
Editing a Host syscli --edit host --wwpn <host_world_wide_port_name> --alias
<host_alias>
This CLI command allows the CLI admin to add or change the host alias of a
host. The required parameter are the existing host's world wide port name
(WWPN) and alias.
Deleting a Host syscli --del host --wwpn <host_world_wide_port_name>
This CLI command allows the CLI admin to delete an existing host from available
host list. The required parameter is the host's WWPN. The host must be inactive
to delete it.
Listing Targets syscli --list target
This CLI command allows the CLI admin to display a list of targets on the system.
It lists the node, alias (FC port) and the WWPN. An example output of a target is
given below.
Listoftargets:
Totalcount=1
[target=1]
node=1
alias=FC3
wwpn=214108001bc08278

Quantum DXi V-Series Specifications

General

Brand	Quantum
Model	DXi V-Series
Category	Storage
Language	English