Quantum DXi V-Series - Editing the Health Check

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Health Check CLI Commands 129
HealthcheckName=De‐Duplication
State=enabled
Started=SunDec1905:00:052010
Finished=SunDec1905:00:052010
Status=Success
HealthCheck=2
HealthcheckName=Integrity
State=enabled
Started=SunDec1905:00:082010
Finished=SunDec1905:00:082010
Status
=Success
Commandcompletedsuccessfully.
Editing the Health
Check
syscli --edit healthcheck --name <healthcheck_name> --enable | --disable
This CLI command allows the admin user to enable or disable the health check
on a specified healthcheck name.
Getting the General
Status of System Health
Checks
syscli --getstatus healthcheck
This CLI command displays the general status of system health checks.
Sample:
bash‐3.2$syscli‐‐getstatushealthcheck
Outputdata:
GeneralHealthchecks
Status=Success
Progress=100%
StartTime=SunDec1905:00:042010
EndTime=SunDec1905:00:092010
Commandcompletedsuccessfully.