Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
22 NAS Configuration CLI Commands
• Listing of Existing NAS Share Names
• Getting the Total NAS Share Count
• Adding a NAS Share
• Editing a NAS Share
• Enabling Allowlinks on a NAS Share
• Deleting a NAS Share
• Deleting All NAS Shares
• Joining or Disjoining a Windows Domain
• Workgroup Users
• Share Administrators
• CIFS Share Access Control
• NFS Share Access Control
• Getting NFS Share Settings
• Changing NFS Share Settings
• Query Status of a NAS Service
• Querying the CIFS Settings
• Setting the CIFS Settings
• Commit NFS Synchronously
• Commit NFS Asynchronously
Listing the Existing NAS
Share and Attributes
syscli --list share [{--proto cifs|nfs} | {--name <share name>}] [--
namematch <pattern>]
This CLI command provides a list of all existing NAS shares on the system and
their attributes. The list can be limited to the type of protocol if --proto is
specified. If --name is specified, only the attributes of that share are listed.
CLI command options:
• --list: Lists all NAS shares.
• * --namematch: If specified, only shares whose names match the specified
pattern are listed. The wild characters ^ and $ are supported as follows:
• ^xxx – matching pattern xxx at the start of names
• xxx$ – matching pattern xxx at the end of names
Remember to escape $ with a backslash because it is special to the shell. For
example, to list all shares ending with test in the names, type the following:
syscli --list sharename --namematch test\$
Note: Option marked with (*) means not supported in Web Services.
To Next Page