Quantum DXi V-Series - Getting the VTL Logical View Status; Getting the Common Component Status; Getting Storage Array Status; Getting Hardware System Component Status

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Status CLI Commands 125
Getting the VTL Logical
View Status
syscli --getstatus vtllogical [--vtl <VTL_name>]
This CLI command returns the logical view of the VTL(s). If an optional VTL name
is specified, only that VTL’s logical view is displayed.
Getting the Common
Component Status
syscli --getstatus commoncomponent [--storagearray ]
This CLI command returns the status of the common hardware components of
the system. If the optional --storagearray option is specified…(TBD)
Getting Storage Array
Status
syscli --getstatus storagearray
This CLI command displays the status of all the storage arrays.
Getting Hardware
System Component
Status
syscli --getstatus syscomponent [--systemboard | --networkport]
This CLI command returns the status of the hardware system components.
Getting System Board
Status
syscli --getstatus systemboard
This CLI command displays the detailed status of the system board components.
Getting Network Port
Status
syscli --getstatus networkport
This CLI command displays the detailed status of the network ports.
Getting Detailed
Storage Array Status
syscli --getstatus storagearraydetails --name <storagearrayname>
This CLI command displays the detailed status of the specified storage array.
Getting System
Memory Usage
Statistics
syscli --getstatus systemmemory
This CLI command displays the memory usage statistics of the system. The
output reports
TotalMemory and FreeMemory.