Quantum DXi V-Series - Displaying the Netserver Status; Displaying the Last Run Result of the Disk;Network Analysis

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
128 Health Check CLI Commands
Displaying the
NetServer Status
syscli --getstatus netserver
This CLI command displays whether NetServer is enabled or disabled on the
system.
Displaying the Last Run
Result of the Disk/
Network Analysis
syscli --show throughput --disk | --network
This CLI command displays the last run result of the disk/network analysis.
Health Check CLI Commands
The following sections describe the supported Health Check CLI commands:
• Starting a Health Check
• Stopping a Health Check
• Listing the Health Check Status
• Editing the Health Check
• Getting the General Status of System Health Checks
Starting a Health Check syscli --start healthcheck
This CLI command allows the admin user to start a healthcheck on the system if
it is not running.
Stopping a Health
Check
syscli --stop healthcheck
This CLI command allows the admin user to stop a healthcheck on the system if
it is running.
Listing the Health
Check Status
syscli --list healthcheckstatus
This CLI command lists the healthcheck status of certain components in the
system.
Sampleoutput:
bash‐3.2$syscli‐‐listhealthcheckstatus
Outputdata:
HealthcheckStatus
Totalcount=2
HealthCheck=1