Troubleshooting
QL-800 User Guide 81
1042 Can't find Job Parameter Job status message does not
contain valid horizontal offset
parameter.
Press and hold the
pause/resume key to cancel
the job. Reprint the job.
Press and hold the power key
on the operation panel for three
seconds to turn the printer off.
Wait three seconds. Then
press and hold the power key
for one second to turn the
printer on again.
1043 Can't find Job Parameter Job status message does not
contain valid vertical offset
parameter.
Press and hold the
pause/resume key to cancel
the job. Reprint the job.
Press and hold the power key
on the operation panel for three
seconds to turn the printer off.
Wait three seconds. Then
press and hold the power key
for one second to turn the
printer on again.
1044 Can't find Job Parameter Job status message does not
contain valid top-of-form
parameter.
Press and release the power
key to resume the job. Or press
and hold the pause/resume key
to cancel the job.
1045 Can't find Job Parameter Job status message does not
contain valid cut at end of job
parameter.
Press and release the power
key to resume the job. Or press
and hold the pause/resume key
to cancel the job.
1046 Can't find Job Parameter Job status message does not
contain valid cut every N
parameter.
Press and release the power
key to resume the job. Or press
and hold the pause/resume key
to cancel the job.
1050 The Maint Cartridge is Full. A print job cannot start if the
maintenance cartridge is full.
Install a new maintenance car-
tridge.
1051 Not ready to print The printer is unable to start a
print job in the current state.
Complete the current task.
Press and release the power
key to clear the error.
10FF Print Engine Error There was an error with the
print engine.
Clear the error using the Main-
tenance Utility or Status Moni-
tor.
# Error Messages Problem Solution
To Next Page
Loading...
Need help?
General