106
Menu Reference
GLOB
Parameter
Options Description
LCD BlinkOff 1-250 x
10 mS
For alternating text displays,
sets the display time for the
secondary display element.
LCD BlinkOn 1-250 x
10 mS
For alternating text displays,
sets the display time for the
primary display element.
LED BlinkOff 1-250 x
10 mS
When the Alert LED setting for
an object is set to Flash, this
is the amount of time the LED
stays turned off.
LED BlinkOn 1-250 x
10 mS
When the Alert LED setting for
an object is set to Flash, this
is the amount of time the LED
stays turned on.
Pri Channels 0-250 Number of priority CONV
channels to check during a
priority scan sampling. “0” sam-
ples all CONV priority channels.
Pri Interval 2-100 x
100 mS
Conventional frequency priority
sample interval.
TGRP Pri Int On or Off Toggles priority interrupt
scanning during trunked calls.
QuickPriRtn On or Off When on, does not wait for
verification of correct CTCSS,
DCS or NAC when returning to
an active CONV channel after
priority sampling
Search Delay 1-250 x
100 ms
Sets wait for reply delay for all
search modes.
SRCH Dig
AGC
On or Off Sets digital AGC mode on or
off for all search types. Useful
to compensate for low or high
digital audio levels caused at
the system.
SRCH
SuprTrk
On or Off Alternative DSP decod-
ing algorithm is applied to
all search types. May help
reception on some systems.
To Next Page
Loading...
