EasyManua.ls Logo

Radioddity GD-88 - Sleep Mode

Default Icon
252 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 97 of 252
[Select]-key to confirm Set OK! pops up on the screen return to the
previous level.
Notes: Most simplex (same RX and TX-frequency) hotspots do not support
the TDMA TimeSlot technique and thus require the Rx TimeSlot and
Tx TimeSlot both to be set to On.
Fullduplex repeaters in general do use the very same TimeSlot for TX
as well as for RX. That´s why there is no differentiation of Rx
TimeSlot and Tx TimeSlot for those.
10.7.4 Sleep Mode
As the Radioddity GD-88 is powered by a battery with limited capacity, it is
advisable to make best use of the battery´s capacity. Therefore, the radio has
special functionalities for saving power and lengthen the battery life.
When the radio is on standby and without any operations, it can be set a delay
time for entering sleep mode automatically.
Users can set the duty cycle (waketime : sleep time) of the power-saving mode.
The smaller the ratio, the lower the power consumption. A higher ratio may result
in a receiving delay or missed calls. So, it is suggested to set the duty cycle based
on its actual use. The set duty cycle is only effective when sleep mode is turned
On.
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[/]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [/]-keys to choose SleepMode and press
the [Select]-key to choose from the following options and procedures:
(1) SlpMode Sw press the [Select]-key to turn it On or Off.
(2) Delay Time press the [Select]-key rotate the [ENC] knob or use the
[/]-keys to choose the delay time between 10 and 60 seconds press
the [OK]-key to confirm Set OK! pops up on the screen and returns to the
previous level.
(3) Duty cycle press the [Select]-key rotate the [ENC] knob or use the
[/]-keys to choose one of the options 1:1, 1:2 or 1:4 and press the
[Select]-key to confirm ‘Set OK!’ pops up on the screen and returns to the
previous level.

Table of Contents

Related product manuals