Raisecom RC953-GESTM1 - 18.2 Interface Command (E1); 18.3 Show Interface Command

www.raisecom.com User Manual
113
Chapter 15 The configuration command under the e1 interface configuration
mode of remote RC952-FEE1.
15.1 autonegotiate
[Command Format]
autonegotiate
no autonegotiate
[Function]
Set the auto negotiate, use no cmnnand to delete the auto negotiate.
[Parameter]
N/A
[Default]
Auto negotiate.
[Command mode]
Remote interface Eth Interface configuration mode.
[Application Example]
RC953-GESTM1#
config
RC953-GESTM1(config)
# remote ric 50
RC953-GESTM1(config-RC952FEE1/1)
# interface eth
RC953-GESTM1(config-RC952FEE1/1-eth/1)
# autonegotiate
Set successfully.
15.2 flow-control
[Command Format]
flow-control {on|off}
[Function]
Flow control is on or off.
[Parameter]
N/A
[Default]
Flow control is off.
[Command mode]