Raisecom RC953-GESTM1 - 5.3 IP Address Configuration

www.raisecom.com User Manual
41
N/A
[Command mode]
Global configuration mode
[Application Example]
RC953-GESTM1(config)# arp delete 192.168.4.250
Successfully delete an entry from ARP table
[Relevant Commands]
Command Description
arp add
Configurate the mapping from a IP address to a physical MAC address.
show arp
Show the current ARP list.
5.3 ip address
[Command Format]
ip address A.B.C.D [A.B.C.D]
[Function]
Configure IP address of snmp port.
[Parameter]
A.B.C.D: IP address.
[A.B.C.D]: Configure the IP subnet mask, Default.
[Default]
N/A
[Command mode]
SNMP interface configuration mode, vcc interface configuration mode.
[Instructions]
ip address, this is mainly used to configure the IP address of the Ethernet port.
[Command Execute Echo]
Successfully set ip address
Information showed when revise IP address successfully.
set ip address failed!
Information showed when revise IP address failed.
[Application Example]
RC953-GESTM1# config
RC953-GESTM1(config)# interface snmp
RC953-GESTM1(config-snmp)# ip address 192.168.4.28