Raisecom RC953-GESTM1 - 28.5 Shutdown Command (ETH); 28.6 Speed Duplex Command; Chapter 32: Device Management (Remote RC954-FE4 E1)

www.raisecom.com User Manual
155
ETH 1 config current
port enable enable disable
autonegotiate disable disable
duplex half-duplex half-duplex
speed 10M 10M
flow-control on off
link-status link-down
tx packets 2946
rx packets 177
rx error packets 0
28.5 shutdown
[Command Format]
shutdown
no shutdown
[Function]
Shutdown the Ethernet interface , use no command to open the Ethernet interface.
[Parameter]
N/A
[Default]
N/A
[Command mode]
Remote protocalEthInterface configuration mode.
[Application Example]
RC953-GESTM1
# config
RC953-GESTM1(config)
# remote ric 1
RC953-GESTM1(config-RC953FE4E1/1)
# interface eth
RC953-GESTM1(config-RC953FE4E1/1-eth/1)
# shutdown
Set successfully
28.6 speed duplex
[Command Format]
speed {10|100} duplex {full-duplex|half-duplex}
[Function]
Set the speed and duplex mode of physical interface.