Raisecom RC953-GESTM1 - 9.7 Interface E1 Command

www.raisecom.com User Manual
82
[Application Example]
RC953-GESTM1# config
RC953-GESTM1(config)# interface e1 1
RC953-GESTM1(config-e1/1)# frame
Set successfully
9.7 interface e1
[Command Format]
interface e1 <1-32>
[Function]
Enter a E1 interface.
[Parameter]
<1-32>: E1 index.
[Default]
N/A
[Command mode]
Interface configuration mode., Global configuration mode
[Application Example]
RC953-GESTM1# config
RC953-GESTM1(config)# interface e1 1
RC953-GESTM1(config-e1/1)# interface e1 2
RC953-GESTM1(config-e1/2)#
9.8 loopback-detection
[Command Format]
loopback-detection (enable|disable)
[Function]
Set the E1 loopback is enable or disable.
[Parameter]
{enable|disable}:
Enable e1 loopback is enable.
Disable e1 loopback is disable.
[Default]
E1 loopback is diable.
[Command mode]