Raisecom RC953-GESTM1 - 9.4 Clock Mode Command (E1)

www.raisecom.com User Manual
80
9.3 bert
[Command Format]
bert {enable|disable}
[Function]
Bert is enable or disable.
[Parameter]
N/A
[Default]
disable
[Command mode]
Interface configuration mode.
[Instructions]
Need to set the remote E1 loopback firstly.
[Command Execute Echo]
N/A
[Application Example]
RC953-GESTM1# config
RC953-GESTM1(config)# interface e1 1
RC953-GESTM1(config-e1/1)# bert enable
Set successfully
9.4 clock-mode
[Command Format]
clock-mode {master|slave}
[Function]
Set the E1 clock mode.
[Parameter]
master: master clock mode.
slave: Slave clock mode.
[Default]
master
[Command mode]
Interface configuration mode.
[Application Example]