Raisecom RC953-GESTM1 - 24.1 Clock Mode Command (E1)

www.raisecom.com User Manual
141
Chapter 24 The configuration command under e1Interface configuration
mode of remote RC953-FX8E1.
24.1 clock-mode
[Command Format]
clock-mode {master|slave}
[Function]
Set E1 clock mode.
[Default]
master
[Command mode]
Interface configuration mode.
[Application Example]
RC953-GESTM1#
config
RC953-GESTM1(config)#
remote ric 1
RC953-GESTM1(config-RC953FX8E1/1)#
interface e1
RC953-GESTM1(config-RC953FX8E1/1-e1/1)#
clock-mode slave
Set successfully.
24.2 crc-auto
[Command Format]
crc-auto {enable|disable}
[Function]
Crc is enable of disable of framed e1.
[Default]
disable
[Command mode]
Interface configuration mode.
[Instructions]
It is disable under clarity mode.
[Application Example]
RC953-GESTM1
# config