Cruise Control Set Indicator Light —
If Equipped
This indicator light will illuminate when the
cruise control is set to the desired speed
page 130.
ECO Mode Indicator Light — If Equipped
This light will turn on when ECO mode is
active.
Front Fog Indicator Light — If Equipped
This indicator light will illuminate when the
front fog lights are on.
LaneSense Indicator Light — If Equipped
The LaneSense indicator light illuminates
solid green when both lane markings have
been detected and the system is armed and
ready to provide visual and torque warnings
if an unintentional lane departure occurs
page 143.
Parking/Headlights On Indicator Light
This indicator light will illuminate when the
parking lights or headlights are turned on.
Turn Signal Indicator Lights
When the left or right turn signal is activated,
the turn signal indicator will flash indepen-
dently and the corresponding exterior turn
signal lamps will flash. Turn signals can be
activated when the multifunction lever is moved down
(left) or up (right).
NOTE:
•
A continuous chime will sound if the vehicle is
driven more than 1 mile (1.6 km) with either turn
signal on.
•
Check for an inoperative outside light bulb if either
indicator flashes at a rapid rate.
•
If equipped with fog lamps, the fog lamp on the side
of the activated turn signal will also illuminate to
provide additional light when turning.
WHITE INDICATOR LIGHTS
Adaptive Cruise Control (ACC) Ready
Indicator Light — If Equipped
This light will illuminate when the vehicle
equipped with ACC has been turned on but
not set
page 131.
Cruise Control Ready Indicator Light
This indicator light will illuminate when the
cruise control is ready, but not set
page 130.
Hill Descent Control (HDC) Indicator
Light — If Equipped
This indicator shows when the HDC feature is
turned on. The light will be on solid when HDC
is armed. HDC can only be armed when the
transfer case is in the 4WD Low position and
the vehicle speed is less then 20 mph (32 km/h). If these
conditions are not met while attempting to use the HDC
feature, the HDC indicator light will flash on/off.
LaneSense Indicator Light — If Equipped
When the LaneSense system is ON, but not
armed, the LaneSense indicator light illumi-
nates solid white. This occurs when only left,
right, or neither lane line has been detected.
If a single lane line is detected, the system is ready to
provide only visual warnings if an unintentional lane
departure occurs on the detected lane line
page 143.
BLUE INDICATOR LIGHTS
High Beam Indicator Light
This indicator light will illuminate to indicate
that the high beam headlights are on. With
the low beams activated, push the multifunc-
tion lever forward (toward the front of the
vehicle) to turn on the high beams. Pull the multifunc-
tion lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are off, pull
the lever toward you for a temporary high beam on,
"flash to pass" scenario.
GETTING TO KNOW YOUR INSTRUMENT PANEL 99
3
To Next Page
Loading...
