NOTE:
•
The engine must be running for the heated seats to
operate.
•
The level of heat selected will stay on until the
operator changes it.
For information on use with the Remote Start system,
see
page 20.
Rear Heated Seats
On some models, the two outboard rear
seats are equipped with heated seats. The
heated seat switches for these seats are
located on the rear of the center console.
There are two heated seat switches that allow the rear
passengers to operate the seats independently. You
can choose from HI, MED, LO, or OFF heat settings.
Amber indicator lights in each switch indicate the level
of heat in use.
•
Push the heated seat button once to turn the HI
setting on.
•
Push the heated seat button a second time to turn
the MED setting on.
•
Push the heated seat button a third time to turn the
LO setting on.
•
Push the heated seat button a fourth time to turn
the heating elements off.
NOTE:
•
The level of heat selected will stay on until the
operator changes it.
•
Once a heat setting is selected, heat will be felt
within two to five minutes.
•
The engine must be running for the heated seats to
operate.
VENTILATED SEATS — IF EQUIPPED
Front Ventilated Seats
Located in the seat cushion are small fans
that draw the air from the passenger com-
partment and move air through fine perfora-
tions in the seat cover to help keep the
driver and front passenger cooler in higher ambient
temperatures. The fans operate at three speeds: HI,
MED and LO.
The front ventilated seats control buttons are located
on the center instrument panel below the touchscreen,
and are also located within the Climate or Comfort
screen of the touchscreen.
NOTE:
If the vehicle is equipped with a 12-inch radio, there will
only be control buttons through the touchscreen.
•
Press the ventilated seat button once to choose HI.
•
Press the ventilated seat button a second time to
choose MED.
•
Press the ventilated seat button a third time to
choose LO.
•
Press the ventilated seat button a fourth time to
turn the ventilation off.
NOTE:
The engine must be running for the ventilated seats to
operate.
For information on use with the Remote Start system,
see
page 20.
HEAD RESTRAINTS
Head restraints are designed to reduce the risk of injury
by restricting head movement in the event of a rear
impact. Head restraints should be adjusted so that the
top of the head restraint is located above the top of
your ear.
WARNING!
•
All occupants, including the driver, should not oper-
ate a vehicle or sit in a vehicle’s seat until the
head restraints are placed in their proper positions
in order to minimize the risk of neck injury in the
event of a crash.
•
Head restraints should never be adjusted while the
vehicle is in motion. Driving a vehicle with the head
restraints improperly adjusted or removed could
cause serious injury or death in the event of a
collision.
NOTE:
Do not reverse the head restraints (making the rear of
the head restraint face forward) in an attempt to gain
additional clearance to the back of your head.
Front Head Restraints
Four-Way Head Restraints — If Equipped
Your vehicle may be equipped with front four-way driver
and passenger head restraints.
To raise the head restraint, pull upward on the head
restraint. To lower the head restraint, push the adjust-
ment button, located at the base of the head restraint,
and push downward on the head restraint.
32 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
