Disconnecting The Rear Camera And
Remote Keyless Entry
1. Open the tailgate to access the rear camera or
Remote Keyless Entry connector bracket located on
the rear sill.
2. Remove the connector bracket from the sill by push-
ing inward in the locking tab.
3. Disconnect the chassis wiring harness, ensuring the
connector bracket does not fall into the sill.
4. Connect the chassis plug and bracket (provided in
the glove compartment) to the chassis wiring har-
ness and insert the bracket back into the sill.
5. Connect the tailgate plug (provided in the glove com-
partment) to the tailgate wiring harness to ensure
that the terminals do not corrode.
Connector Bracket
Locking Tab
Disconnected Harness
Chassis Wiring Harness
Chassis Plug
Wire Harness Bracket
1 — Tailgate Plug Release
2—TailgatePlug
3 — Tailgate Harness
GETTING TO KNOW YOUR VEHICLE 67
2
To Next Page
Loading...
