AUTOMATIC POWER FOLDING
MIRRORS — IF EQUIPPED
When enabled within Uconnect Settings page 174,
the exterior mirrors will automatically fold when the
vehicle’s ignition is placed in the OFF position, and after
the doors are locked and closed.
The exterior mirrors will auto-fold in the following situa-
tions after the ignition is placed in the OFF position:
•
Pushing the lock button on the door panel before
the door is opened.
NOTE:
If the doors are already locked, push the lock button
again.
•
Opening the door, then pushing the lock button on
the door panel, followed by closing the door.
•
After exiting the vehicle, close the doors then push
the lock button on the key fob.
•
After exiting the vehicle, close the doors then touch
the lock icon on the Passive Entry door handle.
If the exterior mirrors were folded automatically, they
will unfold when the ignition is placed in the ON/RUN
position.
NOTE:
If the mirrors were folded manually (pushing the mirror
head inward by hand), OR by using the power folding
mirror switch on the driver’s door panel, they will not
automatically unfold.
TILT SIDE MIRRORS IN REVERSE —
IF EQUIPPED
This feature provides automatic outside mirror positioning
which will assist with the driver’s ground visibility. The out-
side mirrors will move slightly downward from the present
position when the vehicle is shifted into REVERSE. The
outside mirrors will then return to the original position
when the vehicle is shifted out of REVERSE. If the vehicle
is equipped with Driver Memory Settings, this feature will
be linked to the programmable settings.
NOTE:
The Tilt Side Mirrors In Reverse feature can be turned
on and off using the Uconnect system
page 174.
POWER CONVEX MIRROR SWITCH
— IF EQUIPPED
The Power Convex Mirror Switch is located on the door
trim panel, above the power mirror controls. The switch
enables the movement of the convex portion of both
the driver and passenger outside mirrors.
To adjust the convex portion of the outside mirrors,
push the Power Convex Mirror Switch. Then, select the
mirror you want to adjust by using the L (left) or R (right)
buttons. Using the mirror control switch, push any of the
four arrows for the direction you want the mirror to
move.
To return the control to the large mirror, push the Power
Convex Mirror Switch a second time.
NOTE:
If the Power Convex Mirror Switch is not pushed a sec-
ond time, the switch will automatically default back to
the larger portion of the outside mirrors after a period
of time.
Power Convex Mirror Switch
Trailer Tow Power Convex Mirror
40 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
