The Instrument Panel Power Inverter switch is only
found on vehicles equipped with an exterior power
inverter. The switch only controls on/off operation of
the power outlet in the truck bed or, if equipped, the
RamBox. It does not control on/off operation of the
power outlets located inside the cabin of the vehicle.
For information on the outlet found inside the RamBox,
see
page 72.
To turn on the power outlet, simply plug in a device. The
outlet turns off when the device is unplugged.
NOTE:
•
The power inverter only turns on if the ignition is in
the ACC or ON/RUN position.
•
Due to built-in overload protection, the power
inverter shuts down if the power rating is exceeded.
WARNING!
To avoid serious injury or death:
•
Do not insert any objects into the receptacles.
•
Do not touch with wet hands.
•
Close the lid when not in use.
•
If this outlet is mishandled, it may cause an elec-
tric shock and failure.
WIRELESS CHARGING PAD —
IF EQUIPPED
Your vehicle may be equipped with a 15W 3A Qi® wire-
less charging pad located below the center stack,
within the storage compartment. This charging pad is
designed to wirelessly charge your Qi® enabled mobile
phone. Qi® is a standard that allows wireless charging
of your mobile phone.
Your mobile phone must be designed for Qi® wireless
charging. If the phone is not equipped with Qi® wireless
charging functionality, an aftermarket sleeve or a spe-
cialized back plate can be purchased from your mobile
phone provider or a local electronics retailer. Please
see your phone’s Owner’s Manual for further
information.
The wireless charging pad is equipped with an anti-slip
mat to hold your mobile phone in place, and an LED
indicator light.
Place the device inside the prepared area delimited in
the mat as shown in the image. Incorrect positioning
will prevent the phone from charging.
NOTE:
If your vehicle comes with a Wireless Charging pad,
you'll notice a clear indication on the rubber mat with
the text "Wireless Charger" and accompanying phone
and charging icon graphics. The charger is available for
the left side only.
Alternatively, if you have a phone holder in your vehicle,
it has a rubber surface with textured grip for secure
placement, and a designated slot for your charging
cord.
LED Indicator Status:
•
No Light: Charging pad is idle or searching for a
device. Device may not be compatible with the Qi®
standard.
•
Blue Light: Device is detected and is charging.
•
Red Light/Flashing: Internal error, or foreign object
is detected.
•
Green Light: Device has completed battery charging
(if device is equipped to transmit this information).
Instrument Panel Power Inverter Switch
Wireless Charging Pad
GETTING TO KNOW YOUR VEHICLE 61
2
To Next Page
Loading...
