To turn on the headlights, rotate the headlight switch
clockwise. When the headlight switch is on, the parking
lights, taillights, license plate light and instrument panel
lights are also turned on. To turn off the headlights,
rotate the headlight switch back to the O (off) position.
MULTIFUNCTION LEVER
The multifunction lever is located on the left side of the
steering column.
DAYTIME RUNNING LIGHTS (DRLS)
— IF EQUIPPED
The Daytime Running Lights (DRLs) come on whenever
the engine is running, and the low beams are not on. The
lights will remain on until the ignition is placed in the OFF
or ACC position, or the parking brake is engaged.
NOTE:
•
If allowed by law in the country in which the vehicle
was purchased, the Daytime Running Lights can be
turned on and off using the Uconnect system
page 174.
•
On some vehicles, the Daytime Running Lights may
deactivate, or reduce intensity, on one side of the
vehicle (when a turn signal is activated on that
side), or on both sides of the vehicle (when the haz-
ard warning lights are activated).
HIGH/LOW BEAM SWITCH
Push the multifunction lever toward the instrument
panel to switch the headlights to high beams. Pulling
the multifunction lever back will turn the low beams on.
AUTOMATIC HIGH BEAM
HEADLAMP CONTROL —
IF EQUIPPED
The Automatic High Beam Headlamp Control system
provides increased forward lighting at night by automat-
ing high beam control through the use of a camera
mounted on the inside rearview mirror or a windshield
mounted camera. These cameras detect vehicle spe-
cific light and automatically switch from high beams to
low beams until the approaching vehicle is out of view.
NOTE:
•
The Automatic High Beam Headlamp Control can be
turned on or off by selecting “ON” under “Auto Dim
High Beams” within your Uconnect Settings
page 174, as well as turning the headlight
switch to the AUTO position.
•
Broken, muddy, or obstructed headlights and tail-
lights of vehicles in the field of view will cause head-
lights to remain on longer (closer to the vehicle).
Also, dirt, film, and other obstructions on the wind-
shield or camera lens will cause the system to func-
tion improperly.
•
If the windshield or Automatic High Beam Headlamp
Control mirror is replaced, the mirror must be
re-aimed to ensure proper performance. See a local
authorized dealer.
•
The Automatic High Beams will not activate until the
vehicle is at or above 15 mph (24 km/h). To opt out
of the Automatic High-Beam Sensitivity Control
(default) and enter Reduced High-Beam Sensitivity
Control (not recommended), toggle the multifunction
lever six full on/off cycles within 10 seconds of igni-
tion ON. The system will return to the default setting
when the ignition is placed in the OFF position.
FLASH-TO-PASS
You can signal another vehicle with your headlights by
lightly pulling the multifunction lever toward you. This
will cause the high beam headlights to turn on, and
remain on, until the lever is released.
Headlight Switch
1 — Rotate Headlight Control
2 — Push Front/Rear Fog Light Switch
3 — Ambient Light Dimmer Control
4 — Instrument Panel Dimmer Control
5 — Push Cargo Light Switch
Multifunction Lever
42 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
