WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, exhaustion, or
other physical conditions must exercise care when
using the steering wheel heater. It may cause
burns even at low temperatures, especially if used
for long periods.
•
Do not place anything on the steering wheel that
insulates against heat, such as a blanket or steer-
ing wheel covers of any type or material. This may
cause the steering wheel heater to overheat.
UCONNECT VOICE RECOGNITION —
IF EQUIPPED
INTRODUCING VOICE
RECOGNITION
Start using Uconnect Voice Recognition with these help-
ful quick tips. It provides the key Voice Commands and
tips you need to know to control your vehicle’s Voice
Recognition (VR) system.
If you see the NAV icon on the bottom bar or in the Apps
menus of your 8.4-inch touchscreen, you have the
Uconnect 5 NAV system. If not, you have a Uconnect
5 with 8.4-inch display system.
BASIC VOICE COMMANDS
The following basic Voice Commands can be given at
any point while using your Uconnect system.
Push the VR button
or for the Uconnect 5/5 NAV,
say the vehicle’s “Wake Up” word, “Hey Uconnect”.
After the beep, say:
•
“ Cancel” to stop a current voice session.
•
“ Help” to hear a list of suggested Voice Commands.
•
“ Repeat” to listen to the system prompts again.
Notice the visual cues that inform you of your Voice
Recognition system’s status.
NOTE:
On Uconnect 5 systems, the factory default “Wake Up”
word is set to “Hey Uconnect” and can be repro-
grammed through the Uconnect Settings.
GET STARTED
All you need to control your Uconnect system with your
voice are the buttons on your steering wheel.
1. Visit UconnectPhone.com to check mobile device
and feature compatibility and to find phone pairing
instructions.
2. Reduce background noise. Wind noise and passen-
ger conversations are examples of noise that may
impact recognition.
3. Speak clearly at a normal pace and volume while
facing straight ahead. The microphone is located in
the headliner and aimed at the driver.
4. Each time you give a Voice Command, you must first
push either the VR or Phone button, wait until after
the beep, then say your Voice Command. You can
also say the vehicle “Wake Up” word and state your
command. Some examples of “Wake Up” words
include “Hey Uconnect” or “Hey Ram”.
5. You can interrupt the help message or system
prompts by pushing the VR or Phone button and
saying a Voice Command from the current category.
ADDITIONAL INFORMATION
© 2023 FCA. All rights reserved. Mopar and Uconnect
are registered trademarks and Mopar Owner Connect is
a trademark of FCA.
Uconnect Voice Command Buttons
1 — For The Uconnect 5/5 NAV System Vehicles
Equipped With Navigation: Push The Phone Button To
Begin Radio, Media, Navigation, Climate, Start Or
Answer A Phone Call, And Send Or Receive A Text
1 — For The Uconnect 5/5 NAV System Vehicles Not
Equipped With Navigation: Push The Phone Button To
Answer An Incoming Phone Call
2 — Push To Access The Tile Feature
3 — Push The Hang Up Button To End A Call Currently In
Progress
26 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
