NOTE:
•
Keeping your foot on the accelerator pedal can
cause the vehicle to continue to accelerate beyond
the set speed. If this occurs, the message “ACC
Driver Override” will display in the instrument cluster
display.
•
If you continue to accelerate beyond the set speed
while ACC is enabled, the system will not control the
distance between your vehicle and the vehicle
ahead. The vehicle speed will only be determined by
the position of the accelerator pedal.
To Cancel
The following conditions cancel the ACC or Fixed Speed
Cruise Control systems:
•
The brake pedal is applied
•
The CANC (cancel) button is pushed
•
The Anti-Lock Brake System (ABS) activates
•
The trailer brake is applied manually (if equipped)
•
The gear selector is removed from the DRIVE
position
•
The Electronic Stability Control/Traction Control Sys-
tem (ESC/TCS) activates
•
The vehicle parking brake is applied
•
The Trailer Sway Control (TSC) activates
•
The driver switches ESC to Full Off mode
•
The braking temperature exceeds normal range
(overheated)
The following conditions will only cancel the ACC
system:
•
Driver seat belt is unbuckled at low speeds
•
Driver door is opened at low speeds
To Turn Off
The system will turn off and clear the set speed in
memory if:
•
The Adaptive Cruise Control (ACC) on/off button is
pushed
•
The Fixed Speed Cruise Control on/off button is
pushed
•
The ignition is placed in the OFF position
•
4WD Low is engaged
To Resume
If there is a set speed in memory, push the RES
(resume) button and then remove your foot from the
accelerator pedal. The instrument cluster display will
show the last set speed.
Resume can be used at any speed above 19 mph
(30 km/h) when only Fixed Speed Cruise Control is
being used.
Resume can be used at any speed above 0 mph
(0 km/h) when ACC is active.
NOTE:
•
While in ACC mode, when the vehicle comes to a
complete stop longer than two seconds, the system
will cancel. The driver will have to apply the brakes
to keep the vehicle at a standstill.
•
ACC cannot be resumed if there is a stationary
vehicle in front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.
To Vary The Speed Setting
To Increase Or Decrease The Set Speed
After setting a speed, you can increase the set speed by
pushing the SET (+) button, or decrease speed by push-
ing the SET (-) button.
U.S. Speed (mph)
•
Pushing the SET (+), or SET (-) button once will
result ina1mphspeed adjustment. Each subse-
quent tap of the button results in an adjustment of
1 mph.
•
If the button is continually pushed, the set speed
will continue to adjust in 5 mph increments until the
button is released. The new set speed is reflected in
the instrument cluster display.
Metric Speed (km/h)
•
Pushing the SET (+), or SET (-) button once will
result ina1km/hspeed adjustment. Each subse-
quent tap of the button results in an adjustment of
1 km/h.
•
If the button is continually pushed, the set speed
will continue to adjust in 10 km/h increments until
the button is released. The new set speed is
reflected in the instrument cluster display.
134 STARTING AND OPERATING
To Next Page
Loading...
