CAUTION!
Do not place any article under a power seat or
impede its ability to move as it may cause damage to
the seat controls. Seat travel may become limited if
movement is stopped by an obstruction in the seat’s
path.
Power Lumbar — If Equipped
Vehicles equipped with power driver or passenger seats
may also be equipped with power lumbar. The power
lumbar switch is located on the outboard side of the
power seat. Push the switch forward to increase the
lumbar support. Push the switch rearward to decrease
the lumbar support.
Easy Entry/Exit Seat
This feature provides automatic driver’s seat position-
ing to enhance driver mobility when entering and exiting
the vehicle.
The distance the driver’s seat moves depends on where
you have the driver’s seat positioned when you place
the ignition in the OFF position.
•
When you place the vehicle’s ignition in the OFF
position, the driver’s seat will move about
2.4 inches (6 cm) rearward if the driver’s seat posi-
tion is greater than or equal to 2.7 inches (6.77 cm)
forward of the rear stop. The seat will return to its
previously set position when you place the ignition
into the ACC or ON/RUN position.
•
When you remove the key fob from the ignition, the
driver’s seat will move to a position 0.3 inches
(0.77 cm) forward of the rear stop if the driver’s seat
position is between 0.9 inches and 2.7 inches
(2.27 cm and 6.77 cm) forward of the rear stop. The
seat will return to its previously set position when
you place the ignition to the ACC or ON/RUN
position.
•
The Easy Entry/Easy Exit feature is disabled when
the driver’s seat position is less than 0.9 inches
(2.27 cm) forward of the rear stop. At this position,
there is no benefit to the driver by moving the seat
for Easy Exit or Easy Entry.
When enabled in Uconnect Settings, Easy Entry and
Easy Exit positions are stored in each memory setting
profile
page 27.
NOTE:
The Easy Entry/Exit feature is enabled or disabled
through the programmable features in the Uconnect
system
page 174.
HEATED SEATS — IF EQUIPPED
On some models, the front and rear seats may be
equipped with heaters located in the seat cushions and
seatbacks.
WARNING!
•
Persons who are unable to feel pain to the skin
because of advanced age, chronic illness, diabe-
tes, spinal cord injury, medication, exhaustion or
other physical condition must exercise care when
using the seat heater. It may cause burns even at
low temperatures, especially if used for long peri-
ods of time.
•
Do not place anything on the seat or seatback that
insulates against heat, such as a blanket or cush-
ion. This may cause the seat heater to overheat.
Sitting in a seat that has been overheated could
cause serious burns due to the increased surface
temperature of the seat.
Front Heated Seats
The heated seats control buttons are located
on the center instrument panel below the
touchscreen, or located within the Climate or
Comfort screen of the touchscreen.
NOTE:
If the vehicle is equipped with a 12-inch radio, there will
only be control buttons through the touchscreen.
•
Press the heated seat button once to turn the HI
setting on.
•
Press the heated seat button a second time to turn
the MED setting on.
•
Press the heated seat button a third time to turn the
LO setting on.
•
Press the heated seat button a fourth time to turn
the heating elements off.
Lumbar Control Switch
GETTING TO KNOW YOUR VEHICLE 31
2
To Next Page
Loading...
