EasyManua.ls Logo

RAM 2500 2024 - Climate Controls; Automatic Climate Control Descriptions and Functions

RAM 2500 2024
708 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RUN position, Rain Sensing wiper operation can
resume, if it has been selected, and no other inhibit
conditions (mentioned previously) exist.
CLIMATE CONTROLS
The Climate Control system allows you to regulate the
temperature, air flow, and direction of air circulating
throughout the vehicle. The controls are located on the
touchscreen, on the sides of the touchscreen
(if equipped), or on the instrument panel below the
radio.
AUTOMATIC CLIMATE CONTROL
DESCRIPTIONS AND FUNCTIONS
NOTE:
Icons and descriptions can vary based upon vehicle
equipment.
MAX A/C Button
Press and release the MAX A/C button on
the touchscreen to change the current set-
ting to the coldest output of air. The MAX A/C
indicator illuminates when MAX A/C is on.
Pressing the button again will cause the MAX A/C
operation to exit. Pressing other settings will also cause
MAX A/C to exit.
NOTE:
The MAX A/C sets the control for maximum cooling
performance.
The MAX A/C button is only available on the
touchscreen.
A/C Button
Press and release this button on the touch-
screen, or push the button on the faceplate
to change the current setting. The A/C indi-
cator illuminates when A/C is on.
Recirculation Button
Press and release this button on the touch-
screen, or push the button on the faceplate,
to change the system between Recirculation
mode and outside air mode. The Recircula-
tion indicator and the A/C indicator illuminate when the
Recirculation button is pressed. Recirculation can be
used when outside conditions, such as smoke, odors,
dust, or high humidity are present. Recirculation can be
used in all modes. Recirculation may be unavailable
(button on the touchscreen greyed out) if conditions
exist that could create fogging on the inside of the wind-
shield. The A/C can be deselected manually without
disturbing the mode control selection. Continuous use
of the Recirculation mode may make the inside air
stuffy and window fogging may occur. Extended use of
this mode is not recommended. Recirculation mode
may automatically adjust to optimize customer experi-
ence for warming, cooling, dehumidification, etc.
In cold weather, use of Recirculation mode may lead to
excessive window fogging. The Recirculation feature
may be unavailable if conditions exist that could create
fogging on the inside of the windshield.
Uconnect 5 or 5 NAV With 8.4-inch Display Automatic
Temperature Controls
Uconnect 5 NAV With 12-inch Display Automatic
Temperature Controls
48 GETTING TO KNOW YOUR VEHICLE

Table of Contents

Related product manuals