9. Utilizing two people, remove the Tonneau Cover.
NOTE:
Be sure the Tonneau Cover has been folded completely,
and the stowage straps are engaged, before removing
the cover from the vehicle.
TRI-FOLD TONNEAU COVER
INSTALLATION
To install the Tonneau Cover follow these steps:
1. Position the folded Tonneau Cover on the truck bed
and push the cover forward against the front of the
truck bed. The Tonneau Cover centers itself when
placed on the vehicle.
NOTE:
Make sure to always push the Tonneau Cover all the
way forward on the truck bed. Failure to do so might
prevent proper clamp engagement, or interfere with
the electronic tailgate release function (if equipped).
2. Pull down on the first set of clamp handles to
release the clamps from the Stowed Position.
3. Push clamp wires up and under the flange of the
box (or flange of the RamBox rail, if equipped) to the
Semi-Clamped Position.
4. Push clamp handles upward to the clamped position
to properly engage the clamps.
NOTE:
Once clamped, be sure the clamps are not improp-
erly attached to the truck bed flange.
Stowed Position Location Of Front Latches
Stowed Position
Semi Clamped Position
Clamped Position
GETTING TO KNOW YOUR VEHICLE 77
2
To Next Page
Loading...
