NOTE:
Provisions are provided in the bins for cargo dividers
and shelf supports. These accessories (in addition to
other RamBox accessories) are available from Mopar®.
If equipped, a 115 Volt (400 W maximum) inverter may
be located inside the RamBox of your vehicle. The
inverter can be turned on by the Instrument Panel
Power Inverter switch located to the left of the steering
wheel. The RamBox inverter can power cellular phones,
electronics and other low power devices requiring
power up to 400 W. Certain video game consoles
exceed this power limit, as will most power tools.
The Instrument Panel Power Inverter switch is only
found on vehicles equipped with an exterior power
inverter inside the RamBox or truck bed. The switch
only controls on/off operation of the exterior power
inverter; it does not control on/off operation of the
power outlets located inside the cabin of the vehicle.
RAMBOX SAFETY WARNING
Carefully follow these warnings to help prevent personal
injury or damage to your vehicle:
WARNING!
•
Always close the storage bin covers when your
vehicle is unattended.
•
Do not allow children to have access to the storage
bins. Once in the storage bin, young children may
not be able to escape. If trapped in the storage
bin, children can die from suffocation or heat
stroke.
•
In an accident, serious injury could result if the
storage bin covers are not properly latched.
•
Do not drive the vehicle with the storage bin covers
open.
•
Keep the storage bin covers closed and latched
while the vehicle is in motion.
•
Do not use a storage bin latch as a tie-down.
RamBox Emergency Release Lever
As a security measure, an Emergency Release Lever is
built into the storage bin cover latching mechanism.
In the event of an individual being locked inside the
storage bin, the storage bin cover can be opened from
inside of the bin by pulling on the glow-in-the-dark lever
attached to the storage bin cover latching mechanism.
BED DIVIDER — IF EQUIPPED
The bed divider has two functional positions:
•
Divider Position
•
Storage Position
Divider Position
The divider position is intended for managing your
cargo and assisting in keeping cargo from moving
around the bed. There are 11 divider slots along the
bed inner panels which allow for various positions to
assist in managing your cargo.
RamBox Power Inverter
Instrument Panel Power Inverter Switch
Emergency Release Lever
GETTING TO KNOW YOUR VEHICLE 73
2
To Next Page
Loading...
