WARNING!
Drivers must be careful when backing up even when
using the Surround View Camera. Always check care-
fully behind your vehicle, and be sure to check for
pedestrians, animals, other vehicles, obstructions, or
blind spots before backing up. You are responsible for
the safety of your surroundings and must continue to
pay attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
•
To avoid vehicle damage, Surround View should
only be used as a parking aid. The Surround View
Camera is unable to view every obstacle or object
in your drive path.
•
To avoid vehicle damage, the vehicle must be
driven slowly when using Surround View to be able
to stop in time when an obstacle is seen. It is rec-
ommended that the driver look frequently over
his/her shoulder when using Surround View.
NOTE:
If the vehicle is not equipped with a Pickup Box:
•
The bottom wedge of the Top View will be displayed
in black.
•
The Rear Cross Path button will be grayed out.
•
The guidelines will not be overlaid on Top View/Rear
View and Full Screen of Back Up Camera view.
•
Black video will be displayed for the right side of the
Top and Rear View, and full screen of the Back Up
Camera view when the Rear View Camera is not
connected.
To access all camera options when the vehicle is in
REVERSE, select the More Cams button on the sur-
round view screen.
For information on Auxiliary Cameras (if equipped), see
page 154.
TRAILER CAMERAS — IF EQUIPPED
TRAILER SURROUND VIEW
CAMERA SYSTEM
The Trailer Surround View Camera system allows you to
see an on-screen image of the surroundings and the
Top View of a trailer using four mountable cameras.
This occurs whenever the More Cams button is
selected, or when enabled through the Uconnect sys-
tem. The image will be displayed on the Uconnect dis-
play along with a caution note “Check Entire Surround-
ings”. After five seconds, this note will disappear.
NOTE:
•
Trailer Surround View Camera kit is only available for
vehicles equipped with the Surround View Camera
system.
•
The Trailer Surround View Camera system has pro-
grammable settings that may be selected through
the Uconnect system
page 174.
Set Up
The Trailer Surround View Camera system includes an
installation kit with a Trailer Surround View Module and
four Trailer Surround View Cameras that must be
installed on your trailer prior to connecting to your
vehicle. See the installation instructions included with
the Trailer Surround View installation kit for more
information.
NOTE:
The trailer will be connected to the vehicle via the
12-way connector, and the installation location varies
for Conventional or Gooseneck trailers.
For Conventional trailers, the connection from the rear
fascia goes to the receptacle in the bumper.
Conventional Trailer Connection
1 — Rear Fascia Connector
2 — Receptacle
STARTING AND OPERATING 151
4
To Next Page
Loading...
