DRIVER MEMORY SETTINGS —
IF EQUIPPED
This feature allows the driver to save up to two different
memory profiles for easy recall through a memory
switch. Each memory profile saves desired position set-
tings for the following features:
•
Driver’s seat
•
Easy Entry/Exit Seat operation (if equipped)
•
Adjustable pedals (if equipped)
•
Side mirrors
•
A set of desired radio station presets
NOTE:
•
If equipped with power convex mirrors, these mirror
positions will not set as part of a memory profile
page 35.
•
Your vehicle is equipped with two key fobs, each can
be linked to either memory position 1 or 2.
The driver memory settings switch is located on the
driver door, next to the door handle, and consists of
three buttons:
•
The set (S) button, which is used to activate the
memory save function.
•
The (1) and (2) buttons which are used to recall
either of two saved memory profiles.
Programming The Memory Feature
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected
profile from memory.
1. Place the vehicle’s ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., driver’s seat, outside mirrors, adjustable
pedals (if equipped), and radio station presets).
3. Push the set (S) button on the memory switch, and
then push the desired memory button (1 or 2) within
five seconds. The instrument cluster display will
show which memory position has been set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be in PARK to recall a memory
profile.
Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory
Your key fob can be programmed to recall one of two
saved memory profiles.
NOTE:
Before programming your key fob you must select the
“Personal Settings Linked to Key Fob” feature through
the Uconnect system
page 174.
To program your key fob, perform the following:
1. Place the vehicle’s ignition in the OFF position.
2. Select a desired memory profile 1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Push and release button (1) or (2) accordingly.
“Memory Profile Set” (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory set-
tings by pushing the set (S) button, followed by pushing
the unlock button on the key fob within 10 seconds.
Driver Memory Settings Buttons
GETTING TO KNOW YOUR VEHICLE 27
2
To Next Page
Loading...
