Activation
The Dynamic Centerline feature can be activated
through the Uconnect Settings by pressing the Cargo
Camera button, followed by the Adjust Centerline button
on the touchscreen.
If the Dynamic Centerline feature is turned on, the over-
lay will display anytime the Cargo Camera image is
displayed.
Adjusting Centerline
Refer to the following steps to manually adjust the
centerline:
1. Press the Adjust Centerline button located in the
bottom right corner of the Cargo Camera display.
2. Use the arrows on the bottom left corner of the
Cargo Camera display to adjust the centerline hori-
zontally or vertically.
3. Once the desired position is achieved, press the
Accept button to set the centerline to the newly
specified position.
Deactivation
The Dynamic Centerline feature will automatically be
deactivated whenever the Cargo Camera display is
deactivated. It can also be manually deactivated
through the Uconnect Settings
page 174.
NOTE:
•
If the vehicle speed remains below 8 mph
(13 km/h), the Cargo Camera image will be dis-
played continuously until the touchscreen X button
to disable display of the Cargo Camera image is
pressed.
•
The touchscreen X button to disable the display of
the camera image is made available ONLY when the
vehicle is not in reverse.
•
If snow, ice, mud, or any foreign substance builds up
on the camera lens, clean the lens, rinse with water,
and dry with a soft cloth. Do not cover the lens.
Turning Cargo Camera On Or Off — With
Uconnect 5/5 NAV
1. Press the Controls button located on the bottom of
the Uconnect display.
2. Press the Cargo Camera button
to turn the
Cargo Camera system on.
NOTE:
Once initiated by the Cargo Camera button, the Cargo
Camera image will be displayed until the vehicle speed
remains below 8 mph (13 km/h) and the 10 second
timer runs out. The image may be deactivated by press-
ing the touchscreen X button, placing the ignition in the
OFF position, placing the gear selector in PARK, or
pressing the touchscreen X button. On deactivation, the
previous selected screen will appear.
BED RAIL TIE-DOWN SYSTEM —
IF EQUIPPED
CAUTION!
The maximum load per cleat should not exceed
250 lb (113 kg) and the angle of the load on each
cleat should not exceed 45 degrees above horizontal,
or damage to the cleat or cleat rail may occur.
NOTE:
This feature is only available for vehicles equipped with
a RamBox.
There are two adjustable cleats on each side of the bed
that can be used to assist in securing cargo.
Each cleat must be located and tightened down in one
of the detents, along either rail, in order to keep cargo
properly secure.
To move the cleat to any position on the rail, turn the
nut counterclockwise several turns. Then pull out on
the cleat and slide it to the detent nearest the desired
location. Make sure the cleat is seated in the detent
and tighten the nut.
Adjustable Cleats
70 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
