EasyManua.ls Logo

RAM 2500 2024 - Rear Head Restraint Removal; Driver Adjustable Pedals - if Equipped

RAM 2500 2024
708 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE:
The rear center head restraint (Crew Cab) has only
one adjustment position that is used to aid in the
routing of a tether
page 219.
Do not reposition the head restraint 180 degrees to
the incorrect position in an attempt to gain addi-
tional clearance to the back of the head.
Rear Head Restraint Removal
To remove the head restraint, push the adjustment but-
ton and the release button while pulling upward on the
whole assembly. To reinstall the head restraint, put the
head restraint posts into the holes and adjust it to the
appropriate height.
NOTE:
To remove outboard restraints, the rear seat bottom
must be folded up.
WARNING!
A loose head restraint thrown forward in a collision
or hard stop could cause serious injury or death to
occupants of the vehicle. Always securely stow
removed head restraints in a location outside the
occupant compartment.
ALL the head restraints MUST be reinstalled in the
vehicle to properly protect the occupants. Follow
the reinstallation instructions prior to operating the
vehicle or occupying a seat.
DRIVER ADJUSTABLE PEDALS
IF EQUIPPED
The adjustable pedals system is designed to allow a greater
range of driver comfort for steering wheel tilt and seat posi-
tion. This feature allows the brake and accelerator pedals to
move toward or away from the driver to provide improved
position with the steering wheel.
The adjustable pedal switch is located to the left side of
the steering column.
The pedals cannot be adjusted when the vehicle is in
REVERSE or when the Cruise Control system is on. If
there is an attempt to adjust the pedals when the sys-
tem is locked out, one of the following messages will
appear (on vehicles equipped with an instrument clus-
ter display):
Adjustable Pedal Disabled Cruise Control Engaged
Adjustable Pedal Disabled Vehicle In Reverse
NOTE:
Always adjust the pedals to a position that allows
full movement of the pedal.
Further small adjustments may be necessary to find
the best possible seat/pedal position.
For vehicles equipped with Driver Memory Settings,
you can use your remote keyless entry key fob or the
memory switch on the driver’s door trim panel to
return the adjustable pedals to saved positions
page 27.
WARNING!
Do not adjust the pedals while the vehicle is moving.
You could lose control and have an accident. Always
adjust the pedals while the vehicle is parked.
CAUTION!
Do not place any article under the adjustable pedals
or impede its ability to move, as it may cause damage
to the pedal controls. Pedal travel may become lim-
ited if movement is stopped by an obstruction in the
adjustable pedal's path.
Release/Adjustment Buttons
1 Release Button
2 Adjustment Button
Adjustable Pedals Switch
34 GETTING TO KNOW YOUR VEHICLE

Table of Contents

Related product manuals