PARKSENSE FRONT/REAR PARK ASSIST —
IF EQUIPPED
The ParkSense Park Assist system provides visual and
audible indications of the distance between the rear,
and/or front fascia/bumper, and a detected obstacle
when backing up or moving forward (e.g. during a park-
ing maneuver).
For limitations of this system and recommendations,
see
page 142.
ParkSense will retain the system state (enabled or dis-
abled) from the previous ignition cycle when the ignition
is placed in the ON/RUN position.
ParkSense can be active only when the gear selector is
in REVERSE or DRIVE. If ParkSense is enabled at one of
these gear selector positions, the system will remain
active until the vehicle speed is increased to approxi-
mately 7 mph (11 km/h) or above. A warning will
appear in the instrument cluster display when the
vehicle is in REVERSE, indicating the vehicle is above
ParkSense operating speed. The system will become
active again if the vehicle speed is decreased to less
than approximately 6 mph (9 km/h).
PARKSENSE SENSORS
The four ParkSense sensors, located in the rear fascia/
bumper, monitor the area behind the vehicle that is
within the sensors’ field of view.
The sensors can detect obstacles from approximately
12 inches (30 cm) up to 79 inches (200 cm) from the
rear fascia/bumper in the horizontal direction, depend-
ing on the location, type and orientation of the obstacle.
NOTE:
If equipped as a dually, the ParkSense system has six
rear sensors to assist in detection around the dually
flares.
The six ParkSense sensors, located in the front fascia/
bumper, monitor the area in front of the vehicle that is
within the sensors’ field of view. The sensors can detect
obstacles from approximately 12 inches (30 cm) up to
47 inches (120 cm) from the front fascia/bumper in the
horizontal direction, depending on the location, type
and orientation of the obstacle.
NOTE:
The dually flares are only protected when the vehicle is
in REVERSE. There is no detection for the flares when
the vehicle is moving forward.
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen is located within the
instrument cluster display. It provides visual warnings to
indicate the distance between the rear fascia/bumper
and/or front fascia/bumper and the detected obstacle.
NOTE:
If equipped, when Trailer Reverse Steering Control
(TRSC) is active, ParkSense warnings in the instrument
cluster display are suppressed to allow for TRSC warn-
ings
page 159.
STARTING AND OPERATING 139
4
To Next Page
Loading...
