To install the bed divider into a divider position, perform
the following:
1. Make sure the center handle is unlocked using the
vehicle key and rotate the center handle vertically to
release the divider side gates.
2. With the side gates open, position the divider so the
outboard ends align with the intended slots in the
sides of the bed.
3. Rotate the side gates closed so that the outboard
ends are secured into the intended slots of the bed.
4. Rotate the center handle horizontally to secure the
side gates in the closed position.
5.
Lock the center handle to secure the panel into place.
Storage Position
The storage position for the bed divider is at the front of
the truck bed which maximizes the bed cargo area
when not in use.
To install the bed divider into the storage position, per-
form the same steps as you would for the divider posi-
tion, except position the divider fully forward in the bed
against the front panel.
The outboard ends should be positioned in front of the
cargo tie-down loops.
Center Handle And Lock
1 — Center Handle Lock
2 — Handle
3 — Unlocked Position
4 — Locked Position
Aligning Gate To Slots
Side Gates Closed
Storage Position
Cargo Tie-Down Loop
74 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
