Memory Position Recall
NOTE:
If a recall is attempted when the vehicle is not in PARK,
a message will display in the instrument cluster display.
To recall the memory settings for driver one or two,
push the desired memory button number (1 or 2) or the
unlock button on the key fob linked to the desired
memory position.
A recall can be canceled by pushing any of the memory
buttons (S, 1, or 2) during a recall. When a recall is can-
celed, the driver seat will stop moving. A delay of one
second will occur before another recall can be selected.
Programming The Memory Feature
To create a new memory profile, perform the following:
NOTE:
Saving a new memory profile will erase the selected
profile from memory.
1. Place the vehicle’s ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., driver’s seat, outside mirrors, adjustable
pedals (if equipped), and radio station presets).
3. Push the set (S) button on the memory switch, and
then push the desired memory button (1 or 2) within
five seconds. The instrument cluster display will
show which memory position has been set.
NOTE:
Memory profiles can be set without the vehicle in PARK, but
the vehicle must be in PARK to recall a memory profile.
Linking And Unlinking The Remote
Keyless Entry Key Fob To Memory
Your key fob can be programmed to recall one of two
saved memory profiles.
NOTE:
Before programming your key fob you must select the
“Personal Settings Linked to Key Fob” feature through
the Uconnect system
page 174.
To program your key fob, perform the following:
1. Place the vehicle’s ignition in the OFF position.
2. Select a desired memory profile 1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Push and release button (1) or (2) accordingly.
“Memory Profile Set” (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory set-
tings by pushing the set (S) button, followed by pushing
the unlock button on the key fob within 10 seconds.
Memory Position Recall
NOTE:
If a recall is attempted when the vehicle is not in PARK,
a message will display in the instrument cluster display.
To recall the memory settings for driver one or two,
push the desired memory button number (1 or 2) or the
unlock button on the key fob linked to the desired
memory position.
A recall can be canceled by pushing any of the memory
buttons (S, 1, or 2) during a recall. When a recall is can-
celed, the driver seat will stop moving. A delay of one
second will occur before another recall can be selected.
SEATS
Seats are a part of the Occupant Restraint system of
the vehicle.
WARNING!
•
It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in
these areas are more likely to be seriously injured
or killed.
•
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts. In a collision, people riding in these areas
are more likely to be seriously injured or killed.
•
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
28 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
