RAUMEDIC NeuroSmart - Start-up Procedures

RAUMED NeuroSmart Instruction Manual
Manufacturer: RAUMEDIC AG, Hermann-Staudinger-Strasse 2, 95233 Helmbrechts, Germany
zwo-541EN Rev 3 / 2022-05-03
Page 10 of 61
3.2 Start-up
The device (housing, foil keyboard, cable insulation, plug, label) must be visually inspected for in-
tactness every time before being started up. The device must not be used if defects are detected. It
must be returned to the manufacturer immediately.
Visual inspection
• Front foil undamaged (watertight, buttons OK)?
• Name plate fitted and legible?
• Housing and display undamaged (no cracks or sharp edges)?
• Cable connection and Redel coupling visually free from damage?
• Are there any loose parts within the device (shake the device gently)?
• Are the device or accessories dirty?
3.2.1 Connection diagram
The connection diagram with peripheral devices is shown in Figure 1. RAUMEDIC neurosurgical cath-
eters or blood pressure transducers can be connected to the inputs P1/T1 and P2/T2. The pO
2
input
and thus the oxygen measurement function is not available with REF 095284-001. See Figure 1 and
Table 4.
The measured pressures can be forwarded to a follow-up patient monitor via the Out1 and Out2 outputs.
Monitor-specific Cable DATALOGGER are used for this.
Other peripheral devices and associated connection cables are shown in Figure 1 and listed in Section
3.2.2 Accessories.
Table 4: NeuroSmart connectors
Inputs (application part)
Inputs/outputs (SIP/SOP)
Designation
Number
Designation
Number
P1/T1 and P2/T2
Invasive pressure
2
Power (for adapter)
1
P1/T1 and P2/T2
Invasive temperature
2
Out1/2
(Analogue output)
2
P-tel
Telemetry channel pressure
1
Rec output
(Analogue output)
1
pO
2
Oxygen partial pressure
Invasive (REF 095294-001)
1
USB stick interface
(USB-A)
1
PC interface
(USB-B)
1
Ethernet interface
1 (for servicing only)
This document is for information only