Raven Command FLEX II User Manual

CHAPTER
3
System Calibration: Initial Start Up and Calibration Wizard 11
CHAPTER 3 SYSTEM CALIBRATION
INITIAL START UP AND CALIBRATION WIZARD
The calibration wizard must be completed the first time that the system is powered up on the ISOBUS network or
if the default system settings are reset. The calibration wizard allows the operator to quickly configure the Rate
Control Module (RCM) - Sprayer ECU and AIM Command FLEX™ II NCVs if detected.
Review the following sections for assistance with completing the calibration wizard for the AIM Command FLEX™ II
control system.
NOTE: Refer to the UT Operation Manual for other necessary setup or calibration required before operating
the RCM - Sprayer control system or features.
FIGURE 1. Home Page (Basic Display Mode)
TRANSFER UNIVERSAL TERMINALS
The Transfer UT softkey will be displayed if more than one UT is detected on the ISOBUS. Use
this button to switch the RCM - Sprayer working set menu to an alternate UT at any time.
Working Set
Menu
Quick Access
Softkeys
RCM - Sprayer Home Page
Transfer UT

Raven Command FLEX II Specifications

General

Brand	Raven
Model	Command FLEX II
Category	Paint Sprayer
Language	English