CHAPTER 4
24 RCM - Sprayer and AIM Command FLEX™ II Calibration and Operation Manual
PRECISION FARMING SETUP WIZARD
Precision Farming Setup offers advanced section settings and features such as section overlap, on/off look-ahead
values, and individual section fore/aft measurements for unconventional boom configurations.
To start the Precision Farming Setup:
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Applicator Setup tab along the top of the display.
4. Select the Precision Farming Setup button.
NOTE: Some UT displays or task controllers may not be compatible with precision farming settings.
Refer to Chapter 5, Precision Farming Setup, for additional assistance with completing the Precision Farming
Setup Wizard.
NCV CONTROL MODE (SYSTEMS WITH AIM COMMAND FLEX™ II)
NOTE: The NCV Control Mode is only available for RCM - Sprayer with AIM Command FLEX™ II systems and
may only changed outside of an active job. To change modes in the field, the operator will need to
close the job, change the NCV control mode, and then reopen the job.
NOTE: When bypassing AIM Command FLEX™ II nozzle control system:
• NCVs will remain closed.
• Be sure to open manual shut off valves on each nozzle body and enter the appropriate tip size.
To change the NCV Control Mode:
NOTE: Section and NCV control modes are also available via the Active Control Mode readout on the home
page. Refer to Readout Descriptions section on page 33 for additional assistance with the available
Display Settings.
1. Open the UT Menu and select the RCM - Sprayer Menu button.
2. Select the Tools Menu softkey along the right side of the display.
3. Select the Applicator Setup tab along the top of the display.
4. Use the drop-down list to select the appropriate NCV control mode. Review the RCM - Sprayer Features section
on page 6 for information regarding the available options.
RCM - Sprayer Menu Tools Menu Applicator
Setup
UT Menu
Precision
Farming Setup
RCM - Sprayer Menu Tools Menu Applicator
Setup
UT Menu
NCV Control
Mode
To Next Page
Loading...
Need help?
General
