5-12 HSB Series Color LCD Display
Erasing a Waypoint
4. To edit the waypoint name, press the
NAME
soft key.
The
NAME WAYPOINT
window is displayed.
Use the trackpad to enter or edit the name:
Use the left or right side of the trackpad to move the cursor to the character
you wish to change.
Use the top or bottom of the trackpad to scroll through the characters.
When you have finished editing the name, to remove the window, press
ENTER to save the name or CLEAR to cancel the operation. The waypoint
name replaces the waypoint number.
Press ENTER or CLEAR to return to the default soft keys.
5. To edit the waypoint position, press the
EDIT WAYPOINT
soft key, followed
by
POSITION
. The Waypoint Position pop-up is displayed.
Use the soft keys to select
LAT, LON, BRG
or
RNG
.
Use the trackpad to edit the value:
Use the left or right side of the trackpad to move the cursor to the character
you wish to change.
Use the top or bottom of the trackpad to scroll through the characters.
Adjust each parameter until the waypoint position is correct.
When you have finished editing the position, press ENTER to save the position
or CLEAR to cancel the operation. Press ENTER or CLEAR again, the Waypoint
Position window is removed from the screen and the default soft keys are
displayed.
Erasing a Waypoint
You cannot erase the target waypoint or waypoints that are used in routes.
However, you can remove a waypoint from the current route - see Editing a
Route on page 5-21.
If you try to erase a waypoint that is used in a saved route you are warned
“WAYPOINT IS USED IN A ROUTE & CANNOT BE DELETED”
➤ To delete a waypoint using the cursor:
1. Move the cursor over the waypoint, until the letters
WPT
are displayed. The
waypoint soft keys are displayed.
2. Press the
ERASE WAYPOINT
soft key. The waypoint is removed from the
screen and the Waypoint List is updated.
Note: If you have stopped a GOTO (see Stop Follow or Stop Goto on
page 5-27), the target waypoint remains displayed as a target; you need to use
the
CLEAR GOTO
soft key before you can erase the waypoint using the cursor.
EDIT
WAYPOINT
WPT
ERASE
WAYPOINT
To Next Page
Loading...
